arrrgh help!
-
- Aussie Bonsai Fan
- Posts: 52
- Joined: November 1st, 2016, 6:09 pm
- Bonsai Age: 0
- Location: Geelong
Re: arrrgh help!
a few angles
You do not have the required permissions to view the files attached to this post.
- benbonsai
- Aussie Bonsai Fan
- Posts: 438
- Joined: October 2nd, 2016, 5:13 pm
- Favorite Species: Juniper
- Bonsai Age: 7
- Location: Lake Macquarie, Newcastle NSW
- Has thanked: 4 times
- Been thanked: 25 times
Re: arrrgh help!
Maybe not so much with the semi cascade now I can see the tree better.
It's definitely a nice tree though
Check this thread out, possibly something similar
viewtopic.php?f=104&t=18686
It's definitely a nice tree though
Check this thread out, possibly something similar
viewtopic.php?f=104&t=18686
Slow and steady wins the race
- benbonsai
- Aussie Bonsai Fan
- Posts: 438
- Joined: October 2nd, 2016, 5:13 pm
- Favorite Species: Juniper
- Bonsai Age: 7
- Location: Lake Macquarie, Newcastle NSW
- Has thanked: 4 times
- Been thanked: 25 times
Re: arrrgh help!
I was advised by more experienced members that now is a good time to trim.
Just remember that a juniper branch needs green on it to survive.
I'd give it a good soaking in seasol after you prune too.
Just remember that a juniper branch needs green on it to survive.
I'd give it a good soaking in seasol after you prune too.
Slow and steady wins the race
-
- Aussie Bonsai Fan
- Posts: 52
- Joined: November 1st, 2016, 6:09 pm
- Bonsai Age: 0
- Location: Geelong
Re: arrrgh help!
Probably being a little too timid here, lol, the trunk flows down behind, so I can't really see where the apex would be, I am a bit scared to do too much bending incase I crack another branch 

-
- Aussie Bonsai Fan
- Posts: 52
- Joined: November 1st, 2016, 6:09 pm
- Bonsai Age: 0
- Location: Geelong
Re: arrrgh help!
helps if I add the pics
You do not have the required permissions to view the files attached to this post.
-
- Aussie Bonsai Fan
- Posts: 52
- Joined: November 1st, 2016, 6:09 pm
- Bonsai Age: 0
- Location: Geelong
Re: arrrgh help!
Is there a way to bend a branch/trunk upwards? I wanted to bring the trunk into a little more of an upright position